Unlike conventional solar cells, modern high efficiency passivated contacts solar cells like silicon heterojunction (SHJ) cells have excellent surface passivation and use high bulk lifetime wafers which increase the operating injection level of these devices. These solar cell architectures can benefit from having lower doped substrates, with undoped solar cells becoming an attractive option. There has been very limited literature on high bulk resistivity substrates (>>10 Ωcm). This thesis work provides a comprehensive assessment of the potential of high resistivity/undoped substrates for high performance and more reliable silicon solar cells by demonstrating the results from modeling as well as characterization of SHJ solar cells fabricated with high resistivity/undoped substrates under real-world illumination and temperature conditions that the cells/modules experience in the field. In this work, the results from the analytical model demonstrated the effects of various defects, variation in doping and temperature on the performance of silicon solar cells. Experimentally, SHJ cells with bulk resistivities in the range of 1 Ωcm to >15k Ωcm were fabricated, and cell efficiencies over 20% were measured at standard testing conditions (STC) across the entire range of bulk resistivities. The illumination response (0.1-1 sun) and temperature coefficients (25-90 °C) were shown to be independent of the bulk resistivity. No light induced degradation was observed in the n-type SHJ cells of all resistivity ranges whereas high resistivity p-type SHJ cells showed less degradation compared to that of commercial resistivity range (<10 Ωcm). Very high reverse breakdown voltages (over 1 kV) were demonstrated for SHJ cells fabricated with high resistivity wafers. Using simulation, the importance of having cells in the modules with breakdown voltage higher than the series string voltage for safe and reliable operation of the photovoltaic (PV) system was highlighted. The ingot yield can be improved by moving towards high resistivity ranges to manufacture high efficiency reliable solar cells by utilizing the entire ingot and eliminating the need to adhere to narrow resistivity range. Thus, the novel findings from this work can have profound impact on ingot and module manufacturing resulting in significant cost savings as well as improvement in the system reliability.

In order to ensure higher penetration of photovoltaics in the energy market and have an immediate impact in addressing the challenges of energy crisis and climate change, this thesis research focusses on improving the efficiency of the diffused junction silicon solar cells of an already existing line with established processes. Thus, the baseline processes are first made stable and demonstrated as a pilot line at the Solar Power Lab at ASU, to be used as a backbone on which further improvements could be made. Of the several factors that affect the solar cell efficiency, improvement of short circuit current by reduction of the shading losses is chosen to achieve the improvement.

The shading losses are reduced by lowering the finger width of the solar cell .This reduction of the front metal coverage causes an increase in the series resistance, thereby adversely affecting the fill factor and hence efficiency. To overcome this problem, double printing method is explored to be used for front grid metallization. Before its implementation, it is important to accurately understand the effect of reducing the finger width on the series resistance. Hence, series resistance models are modified from the existing generic model and developed to capture the effects of screen-printing. To have minimum power loss in the solar cell, finger spacing is optimized for the front grid design with each of the finger widths chosen, which are narrower than the baseline finger width. A commercial software package called Griddler is used to predict the results of the model developed to capture effects of screen-printing.

The process for double printing with accurate alignment for finger width down to 50um is developed. After designing the screens for optimized front grid, solar cells are fabricated using both single printing and double printing methods and an improvement of efficiency from 17.2% to 17.8%, with peak efficiency of 18% is demonstrated.