The California Department of Transportation (Caltrans) is required to comply

with the National Pollution Discharge Elimination (NPDES) permit, which includes the infiltration of stormwater runoff from highways and implementing soil based best managements practices (BMPs). Stormwater BMPs are in place to prevent pollution in stormwater runoff as well as to facilitate the stormwater discharge from the road. Per this new permit, Caltrans is to install soil based BMPs that can absorb the 85th percentile of a 24-hour stormwater event. In order to absorb the stormwater runoff, the area used is the Clear Recovery Zone (CRZ), which are the road embankments/slopes located adjacent to the roadside. The CRZ must be traversable and recoverable in order to meet roadside traffic safety standards. A major concern for Caltrans is the uncertainty on how these BMPs will affect the safety of a vehicle, if a vehicle were to interact with the soft soils.

In order to provide an insight on the effects of the BMPs, the modeling and simulation of vehicle dynamics under certain interactions between the roadside, soil, and vehicle was completed. The research used computer simulations to quantify the probability of rollover accidents under several different vehicle, driving and ground conditions. The vehicles traversing typical archetype roadsides on soft soil are simulated using MsMac3D software. It was important to model the properties of the vehicle, roadside, mechanical and hydraulic properties of soils realistically in order to obtain an accurate representation of a real-world vehicle and soil interaction.

The outcome was a library of simulations that provided quantifiable data on the effect that soft soils have on the safety and rollover potential of a vehicle traversing the CRZ.

Asphalt pavements deteriorate over time and are subjected to various distresses like rutting, fatigue cracking, stripping, raveling, etc. In this study, an experiment to indirectly assess aggregate stripping was completed in order to evaluate the effect of type of binder, and aging on the binder-aggregate bond under dry conditioning. The asphalts used in the study are commonly used in the state of Arizona, which included both non-polymer modified and polymer modified asphalts. The phenomenon of stripping was simulated using the Bitumen Bond Strength Test (BBS) and evaluated for Arizona binders. The BBS test is a simple test that measures the "pull-off" tensile strength of the bond between asphalt and the aggregate. Polymer modified binders were found to have lower pull-off strength in comparison to the non-modified or neat binder which were found to possess greater pull-off strength, but lower elasticity, causing the failure to become brittle and spontaneous. However, when aged binder was used, the bond strength expectedly reduced for non-polymer modified asphalts but surprisingly increased for polymer modified asphalts. Both un-aged neat and polymer modified binders were observed to have a cohesive failure whereas only the aged polymer modified binders failed in cohesion. The aged non-polymer modified binders were seen to have an adhesive failure.