Hydrophobic ionizable organic compounds (HIOCs) like per- and polyfluoroalkyl substances (PFAS), certain pharmaceuticals, and surfactants have been detected in groundwater, wastewater, and drinking water. Anion exchange resin treatment is an effective process for removal of anionic contaminants from water. Spent anion exchange resins are conventionally regenerated with high alcohol by volume (ABV) methanol in solution with brine. While effective for regeneration of resins saturated with inorganic anions such as sulfate, nitrate, and perchlorate, HIOCs prove more resistant to regeneration. This research investigated the efficacy of using novel cosolvent solutions with brine to regenerate resins saturated with organic carboxylate and sulfonate anions to understand the effects cosolvent properties have on regenerative ability. Experiments were conducted on six PFAS compounds to evaluate trends in regeneration for three alcohols. For all PFAS species, equivalent ABV and brine solutions showed greatest regeneration with 1-propanol over ethanol and methanol. Experiments with the pharmaceutical sodium diclofenac were conducted showing similar regeneration of 75% methanol and 25% 1-propanol for equivalent salt concentrations and higher regeneration with 1-propanol than ethanol and methanol for equivalent ABV. A series of experiments with surfactant dodecylbenzene sulfonate determined that the key parameters to determine regeneration of the resin for an alcohol cosolvent solution were cosolvent volume fraction, molar mass, Kow value, solution ionic strength, and dielectric constant. Individual assessments on the cost-effectiveness, flammability, and sustainability of cosolvent solutions point to possible future experiments and opportunities for recycled distillery waste streams as regenerative solutions for anion exchange resin.

Energy can be harvested from wastewater using microbial fuel cells (MFC). In order to increase power generation, MFCs can be scaled-up. The MFCs are designed with two air cathodes and two anode electrodes. The limiting electrode for power generation is the cathode and in order to maximize power, the cathodes were made out of a C-N-Fe catalyst and a polytetrafluoroethylene binder which had a higher current production at -3.2 mA/cm2 than previous carbon felt cathodes at -0.15 mA/cm2 at a potential of -0.29 V. Commercial microbial fuel cells from Aquacycl were tested for their power production while operating with simulated blackwater achieved an average of 5.67 mW per cell. The small MFC with the C-N-Fe catalyst and one cathode was able to generate 8.7 mW. Imitating the Aquacycl cells, the new MFC was a scaled-up version of the small MFC where the cathode surface area increased from 81 cm2 to 200 cm2. While the MFC was operating with simulated blackwater, the peak power produced was 14.8 mW, more than the smaller MFC, but only increasing in the scaled-up MFC by 1.7 when the surface area of the cathode increased by 2.46. Further long-term application can be done, as well as operating multiple MFCs in series to generate more power and improve the design.