Mineralogy of the Silicon-Rich Mantle: Implications for Mars and Exoplanets

With the InSight mission deploying a seismometer , Martian bulk chemical compositional models are more important than ever. Three largely consistent models for the Martian mantle have been suggested over the past two decades. Of these three, two are fairly similar and one is dramatically different. Of these three, the EH70 (Sanloup et al., 1999) models have the systematically lower divalent cation to silicon ratios as compared to the other model, the DW85 (Dreibus and Wanke, 1985) model. However, impact of such a low (Mg+Fe+Ca)/Si ratio on mineralogy has not been experimentally investigated. Measurements have been made of the mineralogy of the EH70 bulk mantle composition (Sanloup et al., 1999)) through in-situ laser-heated diamond anvil cell (LHDAC) and large volume press (LVP). Majorite-garnet (Mj) dominated mineralogy has been observed up to 25 GPa. Bridgmanite (Bm) begins to appear from 25.2 GPa and continues in a mixed phase with Mj up to 27 GPa at which point only Bm and calcium perovskite (CaPv) remain. Akimotoite (Ak) is stable up to 1873 K, higher by ≈300 K compared to numerical calculations (Connolly, 2009). This may result in an Ak layer in the Martian mantle, something missing in Earth’s mantle. The overall ratio of pyroxene to olivine polymorphs by volume is high, approaching pure pyroxene. This agrees with numerical calculations. Additionally, ferropericlase (Fp) is stable at lower temperatures, suggesting a higher dependence on temperature for its stability, something that is different from Perple_X calculations which show a strong dependence on pressure. Furthermore, Mj, which make up a majority of the volume of EH70 mantles, was measured to increase in Fe content as pressure increases. The more oxidizing conditions coupled with the silicon-rich composition resulted in three times higher Fe3+ content in Mj as opposed to a pyrolite model. This increased Fe3+ meant our Mj composition approached that of skiagite (Ski,Fe2+ 3 Fe3+ 2 Si3O12) and this caused Mj to have a very low compressibility of only 152.8 GPa, lower than any other Mj compositions in literature. This result suggests that a mantle with EH70 bulk composition would have lower than predicted seismic wave velocities , lower than Perple_X predicts. The Al content of Mj was also found to suppress the first derivative of compressibility to 4.45, lower than that of Ski100 at 6.7. Such differences compared with pyrolitic composition are important to estimate the velocity profiles and to model the dynamics of the Martian mantle. This dataset of mineralogy and composition can also model terrestrial exoplanetary mantles. Current measurements of stellar abundances show a wide range of compositions, and especially compositions with (Mg+Fe+Ca)/Si ratios approaching 1 (Brewer and Fischer, 2016). This experimental study of EH70 composition can fill-in this gap.