Temperature effect on unsaturated hydraulic properties of two fine-grained soils and its influence on moisture movement under an airfield test facility

The influence of temperature on soil engineering properties is a major concern in the design of engineering systems such as radioactive waste disposal barriers, ground source heat pump systems and pavement structures. In particular, moisture redistribution under pavement systems might lead to changes in unbound material stiffness that will affect pavement performance. Accurate measurement of thermal effects on unsaturated soil hydraulic properties may lead to reduction in design and construction costs. This thesis presents preliminary results of an experimental study aimed at determining the effect of temperature on the soil water characteristic curve (SWCC) and the unsaturated hydraulic conductivity function (kunsat). Pressure plate devices with volume change control were used to determine the SWCC and the instantaneous profile method was used to obtain the kunsat function. These properties were measured on two fine-grained materials subjected to controlled temperatures of 5oC, 25oC and 40oC. The results were used to perform a sensitivity analysis of the effect of temperature changes on the prediction of moisture movement under a covered area. In addition, two more simulations were performed where changes in hydraulic properties were done in a stepwise fashion. The findings were compared to field measured water content data obtained on the subgrade material of the FAA William Hughes test facility located in Atlantic City. Results indicated that temperature affects the unsaturated hydraulic properties of the two soils used in the study. For the DuPont soil, a soil with high plasticity, it was found that the water retention was higher at low temperatures for suction levels lower than about 10,000 kPa; while the kunsat functions at the three temperatures were not significantly different. For the County soil, a material with medium plasticity, it was found that it holds around 10% more degree of saturation at 5°C than that at 40°C for suction levels higher than about 1,000 kPa; while the hydraulic conductivity at 40°C was at least one order of magnitude higher than that at 5°C, for suction levels higher than 1,000 kPa. These properties were used to perform two types of numerical analyses: a sensitivity analysis and stepwise analysis. Absolute differences between predicted and field measured data were considered to be acceptable, ranging from 4.5% to 9% for all simulations. Overall results show an improvement in predictions when non-isothermal conditions were used over the predictions obtained with isothermal conditions.